Hollywood forums

Note: This is an archived post that was originally sent to the Hollywood mailing list on Sun, 09 May 2010 15:50:27 -0000

HI ALL! I cant found a way to check if a Rexx port was active or not... There's any way to do that? If I try to send a rexx command to an non existing port the hollywood script will exit...

Note: This is an archived post that was originally sent to the Hollywood mailing list on Sun, 09 May 2010 23:12:54 -0000

Try the following code:
Var should be 1 if the port is open.

Note: This is an archived post that was originally sent to the Hollywood mailing list on 10 May 2010 21:48:36 +0200

Hi! Thank you! I will try it asap