Forum for discussion about the Windows IDE of Hollywood
- Posts: 111
- Joined: Tue Dec 13, 2016 9:39 am
- Location: Poland
I'm not sure if this is intended behavior but whenever I put some spaces (8 or more) at the very beginning of the line, save the file, close IDE, open it again and load that file - my spaces turn into tab character (8 spaces = 1 tab).
That is a little bit frustrating in following case:
Code: Select all
move around: ARROWS
talk: CTR ARROWS
look around: l]]
because it looks like "[[.....]]" construction ignores tabulator character and all my alignment is destroyed once spaces are replaced by tab.
- Posts: 2558
- Joined: Fri Feb 12, 2010 3:33 pm
- Location: Germany
This behaviour can be disabled in the settings, see here